Read Time:3 Minute, 16 Second
Table Saw Insert with Splitter. Table Saw Insert with Splitter. Using a splitter is a good idea any time you need to rip a board on the table saw, see photo. The splitter helps prevent the kerf from closing on the back of the blade as you rip long workpieces. Many saws now come with manufactured splitters (or they’re available as an accessory).
· To help adjust the height of our splitter, to ensure it was level side to side and front to back, we took two 4X4s and ran them through a table saw. The 4X4s then had two different set-up heights. We would set the two pieces of wood under the splitter — at whichever splitter height we wanted — and then tighten the bolts that hold the metal …
Table Saw Splitter. Step 1: Steel. I have a Delta Model 36-678. Step 2: Drill. Drill a hole for the attachment bolt. Step 3: Shape. Cut out a section of the stock so that the splitter is of the desired width. Step 4: Kerf. Remove metal from the surface to match the kerf of your table saw blade.
· I saw the Micro Jig MJ Splitter at the High and since I am not ready to spring for a new table saw, anything that makes this one safer is a good thing. Starting at $24.99 for the standard duty model, this Splitter is an excellent solution for updating an old saw.
The trailing end of the splitter is notched in a bit (1/2″) to clear the zero-clearance throat plates I make for this saw. A full-width splitter shaped like the stock part would force me to have to kerf the insert all the way back to the edge, making it less safe and prone to twisting in my opinion.
· Your saw’s splitter and anti-kickback pawls are two important components of accurate and safe rip cuts. As its name implies, the splitter keeps the kerf open after the blade makes the cut, preventing pinching that can burn a cut. Follow this simple procedure to check that the splitter is centered behind the blade.
· I had this splitter on my Unisaw for years till I sold the saw. This splitter is great. It was very easy to set up and align to the blade. It is very solid when in place. To remove you remove the table saw insert, pull the spring loaded knob, and pull out the splitter. To put it in all you need to do is push it down into the holder.
The splitter provides some piece of mind after the cut is made and the wood exits the saw. Dust collection. Table saw is a major contributor to woodshop air pollution. The Shark Guard is very effective at DC. Lastly, don’t forget your PUSH STICK/ BLOCK. Very effective.
· Need splitter for ridgid table saw ts3650. I resently purchased a Ridgid table saw TS3650 for $200.00, in excellent shape. I know the reviews of this saw are mixed but for this price it was worth it for me. Only issue is it’s missing the splitter. Any ideas of what I can do to replace it.
· A riving knife is a safety device that goes into a table saw, radial arm saw, or circular saw during woodwork activities. Usually attached to the saw’s arbor, the riving knife’s singular purpose is to make sawing a much safer task.